Description:1. It has high strength and fast bonding effect, and is suitable for direct fixation of various components, LEDs and heat sinks.2. Good thermal conductivity, strong adhesion, vacuum packaging is not easy to oxidize and dry, good viscosity, short drying time.3. It has good conductivity, a wide operating temperature range (-60 - 200°c) and short-term resistance to 300°c.4. It has a short surface curing time, long storage period, non-toxic, solvent-free, and can be safely used for flexible bonding, heat dissipation, insulation and packaging of electronics, instruments, leds, heat sinks, etc.5. Instructions:1) extruding the product directly during use, rubbing the surface of the adhesive and covering it immediately after use, in case of re-examination2) the constant surface speed is related to the relative humidity and temperature in the air; The higher the temperature, the faster the curing speed, and vice versa.3) recommended thickness: 0.1-0.5mm, the thinner the better.4) use solvent to clean the surface of the bonded object (such as alcohol) before use, avoid cleaning with detergent and apply it after cleaning the surface.6. The packaging is sealing, and the product is covered with a vacuum bag to isolate the air and extend the storage time. Specifications:Thermal properties, strong adhesive adhesive. Specifications: 5g (single)Melting Quantity: 0 (200°c/24 hours)Evaporation: 0.001% (200°c/24 hours)Thermal Conductivity: gt; 0.671 W/m-KImpedance: lt; 0.06Charging Time: 3min (25°c)Track Endurance: 25KgStrength of Connected Buildings: 1.5mapMargin Ratio: gt; 5.1Dissipation Factor: lt; 0.005Package Included:1 x Heat Sink Plaster