Product Description: , This L298N motor driver module is a high power motor driver module used for DC drive and motors and stepper motors. The module consists of L298 motor driver IC and 78M05 5V voltage regulator. The L298N module can control up to 4 DC motors or 2 DC motors with direction and speed control. L298N is a dual h-bridge motor driver, which can control the speed and direction of two DC motors at the same time. . If the power supply voltage of the motor is as high as 12V, we can turn on the 5V regulator, and the 5V pin can be used as output. If you send a high signal to turn on 1 pin, motor A is ready to drive at maximum speed; If a low signal is sent to the 1 pin of switch-on, motor A is off; If you send a PWM signal, you can control the speed of the motor. The engine speed is proportional to the duty cycle. Product Parameters:Driver Chip: dual h-bridge driver circuit L298NVMS power supply area driving part terminal power: 5V - 35V - 35V Partial drive peak current Io: 2A/bridge Logic part Vss power area terminal power: 4.5-5.5V Operating current range of logic part: 0 - 36mA Signal input control voltage range: 4.5-5.5V high low 0V aximum power consumption: 20W Storage Temperature: -25 °C - 130 °C Control Board Size: 55mm*60mm*30mm Packing List: 5 plates are finished and ready to use, no assembly required. Note:Due to manual measurement, please allow 1-5mm error., Because monitors are not calibrated in the same, that the colors of the items shown in the pictures may vary slightly in your computer monitor.