GALVA COLOUR is a zinc-phosphate enhanced paint which primes and covers in one easy application. The addition of zinc phosphate allows the paint to adhere to 'difficult' surfaces which may not be completely free of corrosion or residual old paint. The top-coat paint colour is RAL referenced for accurate colour matching and seamless touch-up and assists with correct colour selection. Ideal for identification of service pipes and for external aesthetic surface repairs. Applications Repair of painted surfaces Long term corrosion protection Touch up of difficult substrates Conduit/pipeline identification Directions Shake until the agitator ball moves freely in the can Use only with adequate ventilation Remove most of the loose dirt with a wire brush Minimum application temperature = 10 C Apply to a clean - dry surface Spray from a distance of approximately 20 - 30 cm Apply a thin even film Best results are obtained with 2 lighter rather than 1 heavy coat Additional coats can be applied after 15 20 minutes Clear the aerosol valve by turning the can upside down and spraying until only propellant escapes Technical Data Appearance : As Paint Colour Minimum application temperature : 10C (substrate temp.) Adhesion : GT = 0/1 Maximum operational temperature : 80C Gloss: satin gloss : (60% @ 60 Gardner) Salt Spray : Tested against ISO 12944-2 category C3: Moderate > 220 hours STORAGE The product may be stored at normal ambient temperatures and has a shelf life of not less than 60 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.