This listing is for 6 piece/s.SPRAY ADHESIVE HS 300 is a high strength adhesive - formulated without Methylene Chloride or other chlorinated solvents. ADVANTAGES High strength formulation Longer open bond time - allows large areas to be covered before film dries Economical good coverage Free from chlorinated solvents APPLICATIONS Spray Adhesive HS 300 will provide high-strength bonds in many different areas; Chipboard and Concrete Insulation Materials Canvas and Leather Paper Wood and Cork Metal Plastic and Rubber Apply an even coating to both surfaces to be bonded from 9 - 12 inches (25 - 30cm). Wait until the adhesive is tack-dry and bond the surfaces together using firm pressure. N.B. May affect certain plastics. Always test a small - inconspicuous area before general use. To prevent blockages - invert the can after use and spray to clear the nozzle. TECHNICAL DATA Appearance : Clear - amber liquid Odour : Acetone SG @ 25C : 0.68 Pressure @ 25C : 3 Bar Discharge rate : 1.7 g/sec Polymer type : Styrene Isoprene Copolymer Tack time : Approximately 2-10 minutes Bonding time : Maximum adhesion in 12 - 24 hours Temperature range : Up to 50C (dried film) Solubility : Soluble in some solvents - insoluble in water Flammability : Classified as extremely flammable under the EC Classification Labelling and Packaging regulation (CLP) 1272/2008 Packaging : 500ml aerosol STORAGE The product may be stored at normal ambient temperatures and has a shelf life of not less than 36 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame. Pack of 6