Solar Lighting Induction Perimeter Board Control LED Street Lamp Radar Sensor Module Outdoor Bulb Panel with Remote ControlSpecification:Applied LED Voltage: 2.8V-3.3VMoc: lt; 10w (60W virtual standard in the market)Solar Panel Max Input: 5V-6V/lt; 20W Induction Rate: Lighting Control Induction + Human Body Radar InductionSensing Distance: 5-10m Induction Time: Illuminate for 15 seconds + Low Light & Long Light Material: ABS + PCPCode Measurement Rate: 81.5*22.8mm/3.3X0.9in Tips: This control panel has no overcharge and over-discharge protection. The battery should have its own protective plate. It is compatible with 3.2V lithium iron phosphate battery and 3.7V lithium battery. It can be used to modify or maintain the solar integrated street lamp. The microwave induction turns on for 15 seconds and turns on slightly. To transport this product conveniently, there is no battery installed in the remote control. You need to buy a AAA battery locally. Connect the battery first, then the LED lamp, and finally the solar panelWhen using a 3.2v or 37v lithium battery, a protective board should be installed on the battery to prevent overcharging and over-dischargingThe surface of the patch parts should not be covered with metal. Otherwise, the detection distance will be shorter or shorter. The sensing surface may penetrate glass or plasticNote:Due to the different monitor and light effect, the actual color of the item may be slightly different from the color showed on the pictures. Please allow 1-2cm measurement deviation due to manual measurement.1 x Lamp Circuit Board1 x Remote Control