This listing is for 2 piece/s.Single row tapered roller bearings are designed to accommodate combined loads, i.e. simultaneously acting radial and axial loads. The projection lines of the raceways meet at a common point on the bearing axis to provide a true rolling action and therefore low frictional moments during operation. The axial load carrying capacity of tapered roller bearings increases with increasing contact angle. Features Low friction The optimized roller end design and surface finish on the flange promote lubricant film formation, resulting in lower friction. This also reduces frictional heat and flange wear. In addition, the bearings can better maintain preload and run at reduced noise levels. Enhanced operational reliability Optimized surface finish on the contact surfaces of the rollers and raceways supports the formation of a hydrodynamic lubricant film. Rigid bearing application A single row tapered roller bearing is typically adjusted against a second tapered roller bearing. By applying a preload, a rigid bearing application can be achieved. Separable and interchangeable The inner ring with roller and cage assembly (cone) can be mounted separately from the outer ring (cup). Furthermore, the separable components are interchangeable. This facilitates mounting, dismounting and also maintenance inspection routines. Specifications Bore: 0.6875 inch / 17.462mm Outside Dia: 1.5700 inch / 39.878mm Width: 0.5450 inch / 13.843mm Cone width B: 14.605mm - 0.5750 inch Cup width C: 10.668mm - 0.4200 inch Dynamic radial rating: 29400N - 6600lbf Static radial rating: 23400N - 5260lbf