The main benefit of split Plummer block housings is their easy installation; pre-assembled shafts can be mounted in them. SNL Plummer blocks are primarily intended for self-aligning ball bearings, spherical roller bearings and CARB bearings. Specifications Shaft diameter da: 80mm. Shaft diameter db: 90mm. Inside space length Ca: 58mm. Spherical seat diameter Da: 140mm. Seal groove diameter Db: 92.5mm. Base width A: 120mm. Flange width A1: 90mm. Complete housing height H: 177mm. Spherical seat centre height H1: 95mm. Foot height H2: 32mm. Distance between attachment bolts J: 260mm. Overall length L: 315mm. Length of attachment bolt hole (radial) N: 28mm. Width of attachment bolt hole (axial) N1: 22mm. Distance between dowel pins J6: 288mm. Axial offset of dowel pins J7: 33mm. Width across labyrinth seal A2L: mm. Felt strip: FS 170. End cover: ASNH 516-613. Breaking loads P0: 350kN. Breaking loads P55: 430kN. Breaking loads P90: 260kN. Breaking loads P120: 190kN. Breaking loads P150: 175kN. Breaking loads: 215kN. Breaking loads Pa: 140kN. Load carrying ability for cap bolts Q120: 220kN. Load carrying ability for cap bolts Q150: 125kN. Load carrying ability for cap bolts Q180: 110kN. Housing: SNL 516-613. Cap bolt, size: M 12x70. Cap bolt, rec. tightening torque: 80Nm. Appropriate attachment bolt, size G: 20mm. Appropriate attachment bolt, rec. tightening torque: 385Nm. Initial grease fill, 20%: 170g. Initial grease fill, 40%: 280g.