The main benefit of split Plummer block housings is their easy installation; pre-assembled shafts can be mounted in them. SNL Plummer blocks are primarily intended for self-aligning ball bearings, spherical roller bearings and CARB bearings. Specifications Shaft diameter da: 100mm. Shaft diameter db: 115mm. Inside space length Ca: 70mm. Spherical seat diameter Da: 180mm. Seal groove diameter Db: 137.5mm. Base width A: 160mm. Flange width A1: 110mm. Complete housing height H: 218mm. Spherical seat centre height H1: 112mm. Foot height H2: 40mm. Distance between attachment bolts J: 320mm. Overall length L: 380mm. Length of attachment bolt hole (radial) N: 32mm. Width of attachment bolt hole (axial) N1: 26mm. Distance between dowel pins J6: 348mm. Axial offset of dowel pins J7: 39mm. Width across labyrinth seal A2L: 178mm. Four-lip seal: TSN 220 L. V-ring seal: TSN 220 A. Labyrinth seal: TSN 220 S. End cover: ASNH 520-617. Breaking loads P0: 470kN. Breaking loads P55: 620kN. Breaking loads P90: 370kN. Breaking loads P120: 280kN. Breaking loads P150: 250kN. Breaking loads: 310kN. Breaking loads Pa: 200kN. Load carrying ability for cap bolts Q120: 620kN. Load carrying ability for cap bolts Q150: 360kN. Load carrying ability for cap bolts Q180: 310kN. Housing: SNL 520-617. Cap bolt, size: M 20x100. Cap bolt, rec. tightening torque: 200Nm. Appropriate attachment bolt, size G: 24mm. Appropriate attachment bolt, rec. tightening torque: 665Nm. Initial grease fill, 20%: 390g. Initial grease fill, 40%: 630g.